2022 Ford Maverick XL Hybrid with Co-Pilot
I got the cheapo cheapest package (only added the Co-Pilot system). While it certainly feels low cost, this gives me wiggle room to upgrade!
Included are some measurements I’ve taken of the FlexBed, pickup bed, along with a closer look at the factory screw holes.
Note: My bed neither has a drop-in nor a spray-in liner.
Rear of Bed (near cab)
- Green: rear wood plank divider slot
- Blue: widest measurement above the wheel wells
- Yellow: Indent on top of wheel wells
- Pink: points to the direction of truck cab, rear wall of bed
Tailgate
- Red: maximum width opening of the tailgate
- Green: Height to top of tailgate lip from the lowest part of bed floor (the concave, not convex portion of floor ridges)
- Blue: denotes the tailgate and both D-pillars
Bed Side
- Hot Pink: denotes truck cab, tailgate, and bed floor
- Beige: location and distance between bedside anchor screw holes
- Medium Purple: distance between first set of bedside screw holes
- Orange: distance between second set of bedside screw holes
- Yellow: distance between third set of bedside screw holes
- Light Blue: distance between fourth set of bedside screw holes
- Green: length of bedside screw hole channel
- Red: length of wheel arch shelf
- Light Green: Space between rear of bed and rear wood divider
- Medium Blue: approximate length of groove on top of wheel arch shelf
- Dark Purple: width of both wood diver slots
- Dark Blue: length of wheel arch shelf before it curves to the side of the bed
- Gold: length of area between D-Pillar and where the wheel arch starts to curve
- Light purple: distance from top of bed to floor of bed
Flex Bed Notes
- The length of the bed = the length of the anterior wood divider slot (43.5in or 110.49cm), making the Flex Bed an almost square flat wall to flat wall (see pictures at bottom of post)
- The pre-drilled bed side holes are in unequal increments
- Bed side anchor point holes are all about 2 inches apart
- The Bedside screw hole channel is useful for turning and fitting the wood dividers for the flexbed
- Floor tie down anchor point holes are different from the bed side ones (scroll down to see more)
- M6 x 1.0 are recommended fasteners (Metric), with 1/4″ is most similar in size (SAE)
Bed Side Anchor (near D-Pillar)
- The anchor holes (side and floor) are not threaded, so you’d either need self-tapping hardware or a tapping set.
- Side anchor holes are M6 sized
Bed Floor Tie Down Anchor Point
- Floor anchor holes are not threaded
- They are larger than M6 screws, so are likely M8 sized
Bed Side Screw Hole
- Bed Side screw holes are threaded
- M8 screws fit perfectly inside
Pictures for Perspective
